Configure the PCoIP session audio bandwidth limit

Specifies the maximum bandwidth that can be used for audio (sound playback) in a PCoIP session.

The audio processing monitors the bandwidth used for audio. The processing selects the audio compression algorithm that provides the best audio possible, given the current bandwidth utilization. If a bandwidth limit is set, the processing reduces quality by changing the compression algorithm selection until the bandwidth limit is reached. If minimum quality audio cannot be provided within the bandwidth limit specified, audio is disabled.

To allow for uncompressed high quality stereo audio, set this value to higher than 1600 kbit/s. A value of 450 kbit/s and higher allows for stereo, high-quality, compressed audio. A value between 50 kbit/s and 450 kbit/s results in audio that ranges between FM radio and phone call quality. A value below 50 kbit/s might result in no audio playback.

This setting applies to the agent only. You must enable audio on both endpoints before this setting has any effect.

In addition, this setting has no effect on USB audio.

If this setting is disabled or not configured, a default audio bandwidth limit of 500 kilobits per second is configured to constrain the audio compression algorithm selected. If the setting is configured, the value is measured in kilobits per second, with a default audio bandwidth limit of 500 kilobits per second.

This setting applies to View 4.6 and later. It has no effect on earlier versions of View.

When this setting is modified during an active PCoIP session, it will take effect immediately.

Supported on: Teradici PCoIP Session
Set audio BW limit in kilobits per second to:

Registry HiveHKEY_LOCAL_MACHINE
Registry PathSoftware\Policies\Teradici\PCoIP\pcoip_admin
Value Namepcoip.audio_bandwidth_limit
Value TypeREG_DWORD
Default Value500
Min Value
Max Value100000

pcoip.admx

Administrative Templates (Computers)

Administrative Templates (Users)